Oak base plates
Product number:
41711
Product information "Oak base plates"
With these oak base plates you can visually enhance your steam engines, Stirling engines, flame eaters or combustion engines. We have the basics in different dimensions. The oak panels are also used in our models. The base plates are delivered untreated. They have the look typical of oak, which is particularly effective after oiling.
Login
Cutsomers also bought
steel pulley 58mm
€15.20*
This steel pulley has an outer diameter of 58 mm. The belt pulley was made in the lost wax process and thus has a very clean and fine surface. The belt pulley is designed for use on model-building combustion engines, Stirling engines, flame guns or steam engines. On these model machines it can be used either as a belt pulley or as a flywheel. It can also be used as a wheel for a model caravan. The belt pulley is supplied as raw material. Due to the clean castings, processing of the outer surfaces is not absolutely necessary.
Dimensions of the 58mm pulley:
Raw diameter: 58mm
Finish diameter: 57mm
Width on the hoop: 20mm
Width at the waist: 20mm
Diameter of collar: 15mm
Weight: 170g
Material: Cast steel (no gray cast iron)
Copper tube soft
€8.80*
The soft copper tube is suitable for all applications in steam model making and for technical model making. The Cu pipe is also suitable for gasoline lines or diesel lines for motorcycles, tractors and vintage cars. The copper tube is very malleable and can be easily bent into narrow radii by hand. Our soft copper pipes are delivered in a ring and are 1000mm long. If you need a 3m long copper pipe in one piece, simply order 3m copper pipe in the desired diameter. In order to keep your waste as low as possible, we always deliver the pipes in one piece in the length you ordered. Matching compression fittings can also be found in our shop.
If you order several meters of a CU pipe diameter, we will always send you the copper pipe in one piece.
The following CU tubes and copper tubes in a ring are available:
3mm x 0.5mm soft copper tube
4mm x 0.5mm soft copper tube
5mm x 0.5mm soft copper tube
6mm x 0.5mm soft copper tube
6mm x 1.0mm soft copper tube
8mm x 1.0mm soft copper tube
10mm x 1.0mm soft copper tube
Round belt 2mm rough
€3.50*
Round belt for driving drive models or small machines. The drive belt has a diameter of 2 mm and a roughened surface. It is made of highly flexible PU material. You can cut the strap to the desired length and then weld it by heating it (lighter or small blowtorch) and pressing it together. These flexible but still very stable straps are ideal for model making.
The drive belt is delivered as a 1 m piece.
Welding the drive belt is very easy. Use either a candle or a small burner with a soft flame. Hold both ends of the strap to the flame until the plastic begins to melt. Then press the two ends of the strap lightly against each other. After the material has cooled, the excess can be removed with a scalpel or small side cutters.